玻璃碳电极的激光改性处理

玻璃碳电极（ＧＣＥ）用激光脉冲照射处理后，电化学反应行为发生很大变化。背景电流减小，Ｆｅ３＋／Ｆｅ２＋氧化还原电对的电极反应速率显著提高，抗坏血酸（ＡＡ）在电极上呈现明显的吸附作用。     

PP－g－AA的制备和表征

用熔融接枝方法制备了聚丙烯－ｇ－丙烯酸（ＰＰ－ｇ－ＡＡ）。用光电子能谱，广角Ｘ射线衍射，红外光谱和化学滴定方法对接枝物进行了定性和定量表征。讨论了单体和引发剂浓度对接枝率的影响，确定了用红外光谱法测定接枝物含量的经验公式     

纳米级BaAl_2O_4微粉的制备和性质

分别用溶胶 -凝胶法、低温固相反应法 ,制得了纳米级BaAl2 O4微粉 ,用电镜观察了其形貌和粒径的大小 ,用X-射线衍射仪进行了物相分析 ,测定了其纯度与晶型 ,讨论了制备方法与粒度大小的相互影响     

Effect of γ-Irradiation on Phenolic Acids in Strawberries

ABSTRACT: The content of phenolic acids in strawberries was determined before and after gamma-irradiation in the dose range 1 to 10 kGy. Fresh whole strawberries were irradiated, acid-base-hydrolyzed, and purified on polyamide columns. The compounds were analyzed by reversed-phase chromatography and detected with a diode-array detector. Dose/concentration relationships were obtained for gallic acid, 4-hydroxybenzoic acid, cinnamic acid, p-coumaric acid, and caffeic acid. Whereas radiolysis of the individual acids in aqueous solutions led to their efficient degradation and to a notable hydroxylation, in the complex matrix of food no hydroxylation products were formed and only the amount of 4-hydroxybenzoic acid was affected by irradiation (build up: 0.68 ± 0.04 mg kg⁻¹kGy⁻¹).     

以齐聚副产物制备耐高温泡沫剂

以齐聚副产物为原料在实验室分别以AlCl3、AlCl3络合物和杂多酸为催化剂合成并经磺化制备了用于提高石油采收率的耐高温泡沫剂，试验结果说明烷基碳数为16的异构烷基苯磺酸盐常温发泡性能最佳，烷基碳数大于20的正构烷基苯磺酸盐高温发泡性能最佳，后者特别适合高温蒸汽驱油。加入适当的非离子助剂及无机盐能够提高磺酸盐的水溶性，改善发泡剂溶液的稳定性。     

甲醇氧化羰化制碳酸二甲酯产物气相色谱分析

以Chromosorb 10 1为固定相 ,气相色谱法分析甲醇氧化羰化制碳酸二甲酯产物中水、甲醇、乙酸甲酯和碳酸二甲酯等组份的含量 ,考察了柱温 ,载气流量对分离度的影响 ,确定了适宜的分析条件 ,并用校正面积归一化法定量。该方法操作简便 ,快速 ,精度高 ,重现性好     

Asymmetric Hydrogenation of Activated Ketones on Platinum: Relevant and Spectator Species

The heterogeneous enantioselective hydrogenation of activated ketones over chirally modified platinum is reviewed with emphasis on identifying the role of the various species observed in this catalytic system. The past years have witnessed a continuous broadening of the scope of this catalytic system including new reactants and modifiers affording over 97% ee. New reaction pathways have been uncovered and the kinetic and mechanistic studies have been faced with a number of complicating factors caused by spectator species and interactions in solution and on the Pt surface. The previously proposed mechanistic models are critically assessed in the light of these new findings.     

三水草酸铀酰的红外激光化学

文章研究了三水草酸铀酰(UO_2C_2O_4·3H_2O)在兆瓦脉冲二氧化碳激光辐照下的红外激光化学反应,它与草酸铀酰的热分解反应不同,反应产物是二氧化铀和二氧化碳。反应的量子效率随激光波长不同而变化。     

功能化的介孔分子筛碱催化性能的研究

以苯甲醛与氰乙酸乙酯的Knoevenagel缩合为模型反应，研究了用γ－氨丙基三乙氧基硅烷或γ－乙二胺丙基三甲氧基硅烷功能化的纯硅介也分子筛HMS（Hexagonal mesoporous silica）的碱催化性能。结果表明，除个别碱基负载量高的样品外，功能化样品对反应显示很高的催化活性，反应的初期活性不仅取决于催化剂上活性中心的密度，而且与载体的孔道结构有关。大孔径载体有利于反应物、产物的扩散，故在高负载量时，大孔径样品比小孔样品有更高的活性。此外，还考察了反应温度、溶剂、反应物配比和催化剂用量等条件的影响以及催化剂的重复使用情况。结果表明，反应可在低于100℃的温和条件下进行，有明显的溶剂效应，反应物配比和催化剂用量存在一最佳值；随使用次数的增加，催化剂逐渐中毒而失活。     

CMS/TiO2杂化材料电流变液的制备及其性能

利用特殊的溶胶凝胶方法原位制备了改性淀粉与无机钛氧化物杂化型电流变材料。实验表明,在强电场下其电流变效应比相同组份的淀粉、二氧化钛混合型电流变液有显著提高,直流电场4 kV/mm,剪切速率5 s-1时,静态剪切屈服强度可达4000 Pa以上。同时,抗沉降性明显改善,静置100 h几乎不沉淀。此外,温度效应也获得一定的优化,在10 ℃~90 ℃的工作温度范围内力学性能保持良好,70 ℃时剪切强度达到最大值。